Aufrufe
vor 2 Jahren

ATH-Heinl Bedienungsanleitung M33

  • Text
  • Wwwathheinlde
  • Rechte
  • Urheberrecht
  • Maschine
  • Technische
  • Tyre
  • Manufacturer
  • Assembly
  • Technical
  • Reserved
  • Vorbehalten
ATH-Heinl Bedienungsanleitung M33

In order to lever the

In order to lever the lower tyre bead, lift the tyre until it is at the same height as the drop-centre of the wheel rim. Then, position the assembly iron between the tyre and the assembly head and lift the tyre directly under the assembly head. Now lever the tyre bead over the wheel rim and commence the rotational motion in the same way as for the upper bead. After disassembly, press down on the gear change pedal to move the assembly tower so it swivels back. Then remove the tyre. 1.3.6 Assembling a tyre In principle, the guidelines of the German Rubber Industry Trade Association (Wirtschaftsverband der deutschen Kautschukindustrie) should be observed when assembling tyres. The tyre valve should be changed before assembly. Clamp and/or set the wheel rim so that the wheel valve is approximately 180 degrees over the assembly head. Cover the tyre and the wheel rim in a sufficient amount of assembly paste. ® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-10 Manufacturer ATH-Heinl GmbH & CO.KG - 11 -

Check whether the assembly head is in the correct position for the wheel rim. If necessary, set it up as described in the subsection “Setting up the assembly head”. Now place the tyre on the wheel rim at an angle so that the assembly head does not touch any parts of the tyre when swivelling. Swivel the assembly tower by pressing the corresponding pedal. Position the tyre so that the tyre bead is under the nose, but still on the guideway of the assembly head. When doing so, ensure that the tyre is opposite the assembly head in the wheel rim depression. Start the rotational movement of the clamping plate. During the assembly process, ensure that the bead run is correct. Failing to ensure this can cause serious damage to the tyre. When working with tubular tyres, the tube must be positioned correctly in the tyre. Ensure that it is positioned in the tyre such that it will not be damaged during the remainder of the assembly process. ® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-10 Manufacturer ATH-Heinl GmbH & CO.KG - 12 -

ATH-Heinl GmbH & Co. KG Gewerbepark 9 92278 Illschwang Deutschland
Tel.: +49 (0) 9666 18801-00 Fax: +49 (0) 9666 18801-01 Web: www.ath-heinl.de Impressum: ATH-Heinl GmbH & Co. KG